C3060A
v1.0, C3060B V1.0
High efficiency wide input voltage
PFC programmable Charger
90V~265VAC input
For 7S LiPo, 8S LiFe battery
1~60Amps 1500W max.
www.chargery.com
page
9
total
19
Remote control operation instructions
1.
Connect to AC source, turn on the charger
2.
After finish initialization, the C3060A enter into idle model
3.
Connect battery and external signal to the charger. Exclude battery
positive and negative, the external signal must be connected to middle
two terminals. The battery voltage will be displayed, but it is less than
battery voltage , it is normal, when start to charge, the battery will be
displayed accurately.
4.
Press Knob enter into battery type interface, alternate battery type and press Knob, enter into
charge setup interface,
a)
Set up cell count,
b)
Set up charge current, it should be the maximal current that the battery can be charged, when
PWM failed, the charger will charge at this current.
c)
Set up end current. At CV phase (constant voltage), when the charging current is lower than
settings, the charger stop charging and the battery fully charged, display KEEP charge status.
The end current is a percentage (1-60%) of charge current setting . Such as if the charge current
setting is 10A, end current is setup to 10%, the end current is 1A.
d)
Set up end voltage, the voltage is cell voltage NOT battery pack total voltage, it must be under
or same as OVP on BMS. C3060A will charge at constant voltage when total battery voltage
reach cell count*setup value.
Note: On the charge mode, cannot setup restart charge and Auto charge.
9.
Press Knob for 3 seconds, the charger will start to charge, the charge current will be modified
according to the Duty cycle of PWM from external device. The higher Duty cycle, the higher current.
The current range is 1A-60A. need decrease the current, please decrease the Duty Cycle and then
increase it.
10.
Finish charge, the beeper sounds 10 times, charge current is zero, and display KEEP status. If need
continue to charge, adjust duty cycle to under 3% then increase gradually to adjust charge current,
start to charge again.
11.
During charge, press Knob stop charging at any time.
Please watch the operation video on
https://youtu.be/KDD-QWLkFQc
