C10325A
v2.2, C10325B V2.2
High efficiency wide input voltage
PFC programmable Charger
90V~265VAC input
For 4S~24S LiPo/LiFe battery
1~25Amps 1500W max.
www.chargery.com
page
9
total
19
Remote control operation instructions
1.
Connect to AC source, turn on the charger
2.
After finish initialization, the C10325A enter into idle model
3.
Connect battery an external signal to the charger. Exclude battery positive
and negative, the external signal must be connected to middle two
terminals. The battery voltage will be displayed, but it is not accurate,
because the charger can protect the battery from reverse polarity
connection and anti spark.
4.
Press Knob enter into battery type interface, alternate battery type and press Knob, enter into
charge setup interface,
a)
Set up cell count,
b)
Set up charge current, it should be the maximal current that the battery can be charged, when
PWM failed, the charger will charge at this current.
c)
Set up end current. At CV phase (constant voltage), when the charging current is lower than
settings , the charger stop charging and the battery fully charged, display KEEP charge status.
The end current is a percentage (1-60%) of charge current setting . Such as the charge current
setting is 10A, end current is setup to 10%, the end current is 1A.
d)
Set up end voltage, the voltage is cell voltage NOT battery pack total votage, it must be under
or same as OVP on BMS. C10325A will charge at constant voltage when total battery voltage
reach cell count*setup value.
e)
On the charge mode, need not setup restart voltage.
8.
Press Knob for 3 seconds, the charger will start to charge, the charge current will be modified
according to the Duty cycle of PWM from external device. The higher Duty cycle, the higher current.
The current range is 1A-25A.
9.
Finish charge, the beeper sounds 10 times, charge current is zero, and display KEEP status. If need
continue to charge, adjust duty cycle to under 3% then increase gradually to adjust charge current,
start to charge again.
10.
During charge, press Knob stop charging at any time.
Please watch the operation video on
https://youtu.be/KDD-QWLkFQc
