C10325A
v2.2, C10325B V2.2
High efficiency wide input voltage
PFC programmable Charger
90V~265VAC input
For 4S~24S LiPo/LiFe battery
1~25Amps 1500W max.
www.chargery.com
page
8
total
19
Remote control charge Mode
COM1 is on the bottom of charger,
connect to Chargery BMS, the charge current will be controlled by
BMS when any cell voltage reach OVP.
Output connector is as below picture, left is charger output connector, right is connected to battery
connector, tow heavy terminal connect to battery positive and negative separately, there are two slim
terminal in middle of connector, it connect to external device. The charge current can be controlled by
remote signal. The signal should be 1KHz 5V or 3.3V square
Note:
1.
To realize remote control charge by external device, please purchase C10325A.
2.
If don’t connect external device, the charger can be operated by manual, if connect the external
device, and send a suitable signal, after press Knob for 3 seconds start to charge, the charge current
will be adjusted according to external signal. External signal can turn off charge (charge current is
zero, the charge status display KEEP), and control charge current at range 1A to 25A.
Warning
PWM signal adjust charge current, increase or decrease 10% maximal each
time per one second.
Charger output connector
battery connector
