ChargePoint Home FlexCharfePoint, Руководство по установке, Страница: 15 / 20

chargepoint.com 15
Install the Charging Cable
1.
Remove the cable clip from the wire
end of the cable, but do not discard it.
2.
Fold the wire ends and insert them
into the bottom hole of the charging
station.
3.
Match the green wire to the ground on
the left terminal of the output block.
4.
Insert the exposed wires into the
corresponding holes, pushing the
cables up until the silver conductors
are no longer visible.
5.
Snap the white levers all the way down
on each wire.
Note:
The white levers are a pinch point. Be
careful of fingers while handling them.
6.
Insert the 4-pin plug into the connector to
the right of the output supply wiring.
7.
While pushing the cable up, slide the
cable clip into the slot. This secures the
cable and acts as strain relief.