7
MAKING THE ICE -CUBE
1.
Press “ON/OFF” on the control panel to begin the ice making cycle.
2.
Select the size of the ice cube by pressing the “Select” button.
3. The ice making cycle lasts 6 to 15 minutes, depending on the size of the ice cube selection
and the ambient temperature. And during the extreme temperature, the lasting time maybe
vary a lot.
4.
If water pump can’t inject water, the ice maker will stop automatically, and the “ADD
WATER
” indicator will be on on the operation panel. Please check the water bottle and
replace a new bottle full of water.
Press “ON/OFF” button again to start the unit again.
And if the new bottle full of water is replaced and the
“ADD WATER” indicater is still on
because of water pump not working properly, please check the two water filter:
A. The water filter is located in the bottom of water tank, first check it is blocked or not.
Otherwise clean it.
B. The water filter is displayed in following figure. Realease the clipper and take
down the water pipe, then take out the water filter and clean it, then install back
and use the clipper to fasten the water pipe again.
WATER PIPE
TOP COVER
WATER FILTER
CLIPPER
Allow the refrigerant liquid inside the compressor at least 3 minutes to settle before
restarting.
5. The ice maker automatically stops working when the ICE light on the operarion panel is on
means that ice basket is full.
ENJOY THE COLD WATER
The cold water can be enjoyed only after the ice-making have worked for more than half hour.
1.Press the button to pop up the cold water faucet.
2. Press the
“WATER” Water Dispensing Button on the operation button to dispense the
cold water to your cup. Release pressing till your cup is full of the cold water.
USING YOUR ICE MAKER
