Char-Broil Traditional 4638200, Инструкция по сборке

Страница: 13 / 16

4638200 • 13
1. Turn gas off at control knobs and gas source.
2. Remove cooking grate and Drip VapoRISER Bar.
3. Discard briquets before removing burner and briquet grate.
4. Remove can from grease clip.
5. Beneath console, disconnect short ignitor wire from
ignitor (A).
6. Remove screw holding collector box (B). Note which
hole on collector box used for attaching to burner.
Remove collector box, clean ceramic portion of
electrode with rubbing alcohol and cloth.
7. Under console disengage burner springs
from burner tubes (C). Do not remove
spring from valve.
8. Remove briquet grate and burner
together, slide backwards, lift up and
out of grill (D). Separate burner and
briquet grate. Remove scale from
briquet grate, replace if necessary.
9. Clean outside of burner with soap and
water. Lay burner upside down on flat surface,
insert garden hose to force water through
tubes. Make sure water comes out of all burner
holes. Open clogged holes with a thin wire.
Shake out excess water and examine holes.
Due to normal wear and corrosion some
holes may become enlarged. If any large
cracks or holes are found replace burner.
10. If grill is to be stored, coat burner lightly with
cooking oil. Wrap in protective cover to keep insects
out. If not storing the grill, hold briquet grate and burner
together, angle into grill bottom (D) and proceed with
following steps.
11. After cleaning, insert wire and electrode into hole in
grill bottom (A). Reattach collector box to burner with
screw (B). Be sure to use correct hole.
12. Place ends of springs into holes on underside of burner
tubes (C) as before to secure burner.
VERY IMPORTANT: Burner tubes must engage valve
openings as shown (E).
13. Reattach round connector of ignitor wire to ignitor.
14. Do not use more than 16 new briquets on briquet grate
around burner. Do not let briquets cover burner holes.
15. Reposition Drip VapoRISER Bar and cooking grate.
Reattach clean can to grease clip.
16. Before cooking again on grill, follow Burner Flame Check .
Burner
Spring
Valve
Screw
Collector Box
Spring
Burner attached to
Valve
Wire
Round
end to
ignitor
Briquet
Grate
E
C
B
A
D
Electrode
Burner
Cleaning The Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
Typical spider webs
inside burner
Clean burner prior to use after storing, at the beginning of
grilling season or after a period of one month not being
used. Spiders and insects like to build nests in
burner tubes (especially during colder
months). These nests can cause fires
in burner tubes or under grill.