12 4638200
Match Lighting
s
Do not lean over grill while
lighting.
1.
Open lid.
Turn on gas at gas
source.
2. Place lit match into match
lighting hole from outside grill bottom
(as shown).
3. Push in and turn RIGHT knob to IGNITE. Be sure
burner lights and stays lit.
4. Light left burner (if featured) by pushing LEFT knob in and
turning to IGNITE.
After Lighting: Turn Knob(s) to HIGH for warm-up.
Burner Flame Check
Light burner, rotate knobs
from HIGH to LOW. You
should see a smaller
flame in
LOW position
than seen on HIGH.
Always check flame prior to each use. If only low flame is seen
refer to "Sudden drop or low flame" in the Troubleshooting
Section.
Turning Grill Off
Turn all knobs to OFF position. Turn gas OFF at gas source.
Ignitor Check
Turn gas off at gas source.
Press ignitor button rapidly. "Click"
should be heard and spark seen each time between collector
box or burner and electrode. See Troubleshooting if no click or
spark.
Valve Check
Important: Make sure gas is OFF at gas source before
checking valves
. Knobs lock in OFF position. To check valves,
first push in knobs and release; knobs should spring back. If
knobs do not spring back, replace valve assembly before using
grill. Turn knobs to
LOW
position then turn back to
OFF
position.
Valves should turn smoothly.
Match lighting hole is
in bottom
HIGH
LOW
General Grill Cleaning
Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory (and should never be painted). Apply a strong solution
of detergent and water or use a grill cleaner with scrub brush
to insides of grill lid and bottom. Rinse and allow to
completely air dry.
Do not apply a caustic grill/oven cleaner
to painted surfaces.
Plated wire grates:
Wash grates and Drip VapoRISER Bar
with concentrated grill cleaner or use soap and water solution.
Dry thoroughly and store indoors between cookouts.
Plastic side shelves:
Wash with warm soapy water and wipe
dry.
s
Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic side shelves. Damage to
and failure of shelves can result.
Porcelain grate:
Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner.
Use nonabrasive scouring
powder for stubborn stains.
Briquet grate:
Grate will eventually decompose and weaken
with use. Remove grate from grill and tap to loosen any
scaling. Brush grate vigorously with a wire brush to remove
any additional scaling, rust or residue.
Care Of Wood
Wood items can be sanded lightly with fine grit sandpaper.
Refinish with stain, paint or water sealant.
Post Inspection
If the in-ground post mount option is used, inspect post
annually for corrosion (rust).
Use only in-ground post mount with protection against
corrosion (paint or other coating) suitable for conditions in
your area.
Repainting Your Grill
After extended use and exposure to weather, paint on grill
may deteriorate or become spotted. Although this detracts
from grill's appearance, it will not impair its performance.
To refinish your grill brush outside of grill lid and bottom with
wire brush and lightly sand with fine grit sandpaper. Sanding
allows new paint to adhere more easily. Wash grill lid and
bottom with soap and water to remove dust and grease. Do
not use a grill cleaner on outside of grill. Wipe with vinegar.
Refinish the outside with heat-resistant paint.
Do not paint
inside of grill.
If burner does not light turn knob(s) to OFF, wait 5
minutes, try again.
Содержание Traditional 4638200
Страница 16: ...16 4638200 ...
