Char-Broil 463269311, Руководство по эксплуатации продукта

Страница: 24 / 32

16
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module. Total (5) connections, shown A .
Connect the two wires [(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).
Total (2) connections, shown A .
ignition module
Electronic
Left side panel
B
C
Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart left side panel with
the nut, shown B
Insert AA battery into ignition module, negative (
-
) end first. Then put on the cap, shown C .
Nut
-
+
AA battery Cap
3
1
2
4
5
(a)
(b)
ignition module
Electronic
A
15
Inside of cart, insert rear shield tabs into slots next to grease tray opening on upper back panel, shown A .
Attach front shield tabs(with holes) under front brace with two #8x3/8” self-tapping screws, shown B .
Tank heat shield
Cart lower back panel
Front Brace
#8x3/8”
self-tapping screw
for clarity of illustration
Note: some parts omitted
B
Upper back panel
Grease tray opening
rear tab
front tab
(w/hole)
Rear
Front
Tank heat shield
A
24