8 • 463234703
16. Secure grill head to all cart legs using 4 of the
1/4x21/2"
Phillipshead screws and
1/4" nuts
. (Nuts may be welded
in place)
See Fig. 6
.
17.
Fully tighten all leg screws, rear panel screws, door
bracket screws, and grill head screws.
18. From the back of the cart, slide the grease draining tray into
the grill head. Place the grease receptacle into the notches
on the bottom of the tray.
See Fig. 6
.
20. Unscrew the ignitor cap located on the control panel and
remove the contact and spring from the ignitor slot. (Ignitor
Postion may vary from illustration)
See
Fig. 7
.
21. Place the supplied AA battery into the ignitor slot with the
positive pole facing toward you.
22. Place the spring with contact over the battery. Screw the
ignitor cap back onto the control panel.
FIGURE 6
Grease
draining
tray
Grease
receptacle
Attach grill head
to all 4 legs
23. Assemble the regulator mounted on the "L" bracket onto
the Left rear leg with 3/16" X 1/2" Phillip's head screw.
See
Fig. 9
.
FIGURE 9
Contact
Spring
AA Battery
FIGURE 8
Ignitor
cap
+
–
19. Insert the orifice through the Orifice Support
Bracket and into the air shutter of side burner. See
Fig. 7.
Attach the front panel with the valve stem going through the
front panel. Fix the front panel using screws and nuts.
Assemble both valve and control knob seat to front panel
using the same screws. Connect the wire from grill head to
the other wire of electrode assembly. See
Fig. 7a
.
FIGURE 7
Orifice Support
Bracket
Sideburner
Valve
FIGURE 7a
Control
Knob
Control
Knob Seat
Front
Panel
Regulator
with "L"
bracket
Electrode & wire
Assembly
Wire from Grill
head
Valve
Orifice
Air Shutter
