8 • 463232103
FIGURE 6
14. Secure grill head to all cart legs using 4 of the
1/4x21/2"
Phillipshead screws and
1/4" nuts
.
See Fig. 6
.
15.
Fully tighten all leg screws, rear panel screws, door
bracket screws, and grill head screws.
16. From the back of the cart, slide the grease draining tray into
the grill head. Place the grease receptacle into the notches
on the bottom of the tray. Assemble the 3 tool hooks
provided to the front panel on the right shelf by inserting the
thin end of the hook first into the holes provided and sliding
all thru.
See Fig. 6
.
Grease
draining
tray
Grease
receptacle
Attach grill head
to all 4 legs
Contact
Spring
AA Battery
18. Unscrew the ignitor cap located on the control panel and
remove the contact and spring from the ignitor slot.
See
Fig. 8
.
19. Place the supplied AA battery into the ignitor slot with the
positive pole facing toward you.
20. Place the spring with contact over the battery. Screw the
ignitor cap back onto the control panel.
FIGURE 8
Ignitor
cap
+
–
21. Attach panel to front of left side shelf by placing top lip of
panel
ABOVE
bottom lip of shelf. Secure using three
3/16"x3/8"
Phillipshead screws and
3/16" nuts
. Fully
Tighten. See
Fig. 9
.
Panel lip
FIGURE 9
22. Place the 3 flame tamers on the lower ledge above
burners. See
Fig. 10
. They should meet in the center.
23. Place the cooking grids on the ledge above the
flame tamers.
24. Place the secondary cooking rack into the slots on the
upper left and upper right of the grill bowl panels.
17. Place your LP gas tank (
not included
) into the tank hole in
the bottom shelf. Be sure the tank valve is facing forward.
Secure tank by tightening the wing screw at the rear
of the bottom shelf.
See.
Fig. 7
.
READ USE & CARE SECTION BEFORE ATTACHING
REGULATOR TO LP TANK.
FIGURE 7
LP gas
tank
Tool Hooks
Shelf
lip
