Char-Broil 463224611, Руководство по эксплуатации продукта

Страница: 18 / 32

9
8
First, remove the two screws and lock washers factory attached to the sideburner valve bracket.
Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia, making sure “OFF” is on the top. Attach using two
#8-32x3/8”
screws and
4mm
lock washers. Press sideburner
Control knob
Control knob bezel
Install bezel with “OFF” at top.
Sideburner
valve bracket
Screws and Washers
removed from valve bracket
Valve stem
#8-32x3/8” screw
4mm
lock washer
Sideburner
fascia
Note: Use left and right
holes on fascia to
attach valve bracket
Note: Use upper and lower
holes on fascia to attach bezel
18
OFF
Hi
Qty.2
Qty.2
#8-32x3/8” screw
4mm lock washer
control knob onto valve stem.
Pull out the four knobs from control panel. Insert temperature gauge stem into the bigger hole above knob bezel,shown
A
.
Make sure the gauge is pushed in as far as it will go, then push the gauge downward until it clips into the panel, as shown
in
B/C
. Re-install the knobs.
Knob
Knob bezel
Temperature gauge
Temperature gauge stem
Control panel
A
C
B
Back of the panel