Installing the Wall Dock
(3-gang Installation)
6
Installing the Wall Dock
Installation Steps
1. Connect all wiring.
2. Attach main chassis to j-box using
the provided four 6-32 screws.
3. Feed the dock connector circuit
board through the opening in the
front cover.
4. Hang the front cover on the main
chassis from the two top tabs.
5. Secure the front cover with the
two small screws at the bottom.
6. Place the dock platform over
the slide rail and push
downward until the retention
snaps are engaged.
7. Slide the side protectors
into the slots on the main
chassis.
Retention
Snap
Slide Rail
2
2
4
3
5
6
6
7
5
2
1
In some installations it may be desirable to mount a single gang control
keypad next to the A0317. To accomplish this, the single gang trim plate
can be installed next to the A0317 in a 3-gang junction box.:
4
3
Completed Installation
7
Steps 3 & 4 complete
Steps 5 & 6 complete
Installation Steps:
1. Connect all wiring. Use the correct
installation tools: J-110 tool, or
1014 crimp tool.
2. Install keypad and single-gang
trim plate in the far left position
of the 3-gang junction box.
(See details on page 3)
3. Leave off the right side
flange and trim piece.
4. Install the iPod dock in the
left side of the 3-gang j-box.
It will overlap and snap into
the single gang trim plate.
(See page 5 for details)
See attachment
detail on previous page
3
Completed Installation
