4
ASSEMBLY TOOLS REQUIRED
1 - Compass
1 - 10mm Nut Driver
1 - 13mm Deep Socket (
³⁄₈
” Drive)
1 - Clinometer
1 - 10mm Socket (
³⁄₈
” Drive)
1 - 9” Magnetic Level
1 - 10” Adjustable Wrench
1 - Phillips Screwdriver (#1 or #2)
1 - 13mm Combination Wrench
1 - Ratchet Wrench (
³⁄₈
” Drive)
1- Torque Wrench
1 - 10mm Combination Wrench
PREINSTALLATION MATERIALS CHECKLIST
Grounding Rod Clamp & Grounding Block - As Required by National Electric Code or local codes.
Ground Wire - #10 solid copper as or required by National Electric Code or local codes (length required).
Concrete - (See Ground Pole section for quantity and grade).
#3 Rebar - (See Ground Pole section for quantity). Deformed steel per ASTM A615, grade 40 or 60.
SITE SELECTION
The first and most important consideration when
choosing a prospective antenna site is whether or not the
area can provide an acceptable “look angle” at the
satellites. A site with a clear, unobstructed view is pre-
ferred. Also consider obstruction that may occur in the
future such as the growth of trees. Your antenna site must
be selected in advance so that you will be able to receive
the strongest signal available. To avoid microwave
interference, obstructions, etc. conduct an on-site survey
with a portable antenna.
As with any other type of construction, a local building
permit may be required before installing an antenna. It is
the property owner’s responsibility to obtain any and all
permits.
Before any digging is done, information regarding the
possibility of underground telephone lines, power lines,
storm drains, etc. in the excavation area should be
obtained from the appropriate agency.
Because soils vary widely in composition and load
capacity, consult a local professional engineer to
determine the appropriate foundation design and
installation procedure. A suggested foundation design
with conditions noted is included in this manual for
reference purposes only.
