6
.
Load Head Assembly by inserting hose into post.
.
Insert Head Assembly into post.
.
Control knob should be above decal on post.
.
Attach Head Assembly to post, and loosely install four
small bolts.
.
Tighten bolts securely.
(For models with Entire Reflector , skip to Step 9)
Step 8 – Install Reflector
WARNING
Remove protective cover before assemble.
Note: Leave all screws and nuts loose until entire shield is
sections are aligned.
.
Slide two reflector panels together.
.
Insert one small screw.
.
Attach Cap Nut and loosely tighten.
.
Place Reflector center plate into middle of reflector panels
.
Repeat procedure to complete the assembly of all four
sections.
.
Fully tighten all of the screws in the rolled edge.
9 Req’d Small Screws
9 Req’d Cap Nuts
Step 7 – Attach Head Assembly to Post
.
Unscrew 4 small bolts from head assembly.
from Head Assembly
4 Req’d Small Bolts
and follow same procedure above.
put together to ensure proper alignment. Tighten after
