Laser.changhong.com
12
Installation
1.
Correctly distinguish the top and bottom of the screen
：
Place the assembled screen vertically on the ground. Look down on the screen, if the material is black it is
in the correct direction and ready for mounting on the wall. However, if the material is white, turn around
the screen and then install it.
Note: There are also “Top” and “Bottom” labels on the back of the screen material to help distinguish
the correct direction. Please make a note of this.
2.
Preparing for installation
1)
Locate your desired installation location with a stud finder (recommended) and mark the drill-hole area of where
the screen is to be installed. (The distance of the holes is between 1/3 to 2/3 the length of the horizontal frame.)
2)
The installation height must be based on your projector’s throw height and the distance between your projector and
the screen, since this screen is just for Ultra-Short-Throw Projectors. Please refer to your projector’s distance
calculator for proper measurements.
3.
Fixed installation
1)
Drill a hole with the proper bit size according to the wood screws included.
2)
Line up the wall brackets with the drilled holes on the installation location and screw them in using a Phillips
screwdriver.
3)
Position the frame screen onto the
wall brackets (F)
as shown
below
.
4)
The design of the wall brackets allows the frame to slide over them through its sides. This is an important feature of
the installation design as it allows your screen to be properly centered.
21T
For a local Changhong Screens contact or Technical Support, please visit
U
Laser.changhong.com
Wall
Frame
Bracket
