Installation Guide
When the TV is initially powered on, a sequence of on-screen prompts will assist in
configuring basic settings. Press the ENTER button to start the guide. Press the button
to go to the next step. Press the button to return to the previous menu.
■
TV Mode: Press the
▲
/
▼
button to select retail or home.
■
Language: Press the
▲
/
▼
button to select the desired language using the OSD(On
Screen Display).
■
Time Zone: Press the
▲
/
▼
button to select your time zone.
■
Time Format: Press the
▲
/
▼
button to select 12-hour or 24-hour.
■
Antenna: Press the
▲
/
▼
button to select the signal type for channels.
■
Auto Tuning: Scans and saves available programs automatically.
NOTE:
• If the TV doesn't receive any channels, please check your aerial connection or the
country you selected, then try an auto tuning again.
• If the TV just receives some of the channels, it means the aerial's reception isn't good
enough and an antenna service is recommended.
Hotel Menu
Press the
button to display the Source Menu, then press “2012” to enter into the
Hotel Mode to adjust the relative settings.
■
Hotel Enable: Set the Hotel Enable On/Off by pressing the
◄
/
►
buttons.
• When Hotel Mode is On, the Channel function is locked.
■
On Source: Set the default signal source by pressing the
◄
/
►
buttons. (The default
signal source will be displayed when the TV is turned on.)
■
On Channel: Set the default channel by pressing the
◄
/
►
buttons. (The default
channel will be displayed when the TV is turned on.)
■
On Volume: Set the default volume by pressing the
◄
/
►
buttons. (The default volume
is the volume when the TV is turned on. Remember the default volume should be less
than the maximum volume).
■
Volume Max.: Set max volume by pressing the
◄
/
►
buttons. When the max volume is
lower than the default volume, the max volume is the priority.
■
Logo Select: When the "Hotel Enable" and "Logo Select" are both ON, the Logo is
displayed when power on.
■
BACKUP: "BACKUP" means to write the TV data to USB device. The function is
supposed to be used when all the settings have been completed and the "Hotel
Enable" is ON.
■
RESTORE: "RESTORE" means to read data from USB device and write to local flash,
then the machine needs a restart to initiate the parameters.
Connection and Setup
8
