1.The flat panel can easily topple over due to external force, as shown in the following
figure, which should be prevented.
2.Two brackets on the rear cover of the flat panel are required to be installed. Refer to
the diagram shown below for installation location.
3.Finally, the flat panel is assembled as shown in the following figure to prevent from
toppling over due to any external force.
Remarks:
1.The flat panel can only be placed on a flat surface object with a surface area larger
than that of the flat panel. Both supporting brackets on either
side must rest on
the flat surface and the two brackets must be fastened with screws to the left and
right corners of the flat panel’s rear cover respectively.
2.Any issue related to usage safety shall be the liability of the user in the event that the
product is not set up properly according to requirements described in the instruction
manual.
3.The above figures are for reference only, and the physical flat panel shall govern.
Bracket×2
Installation Instructions for the Flat Panel Support Brac
k
et
:
Screw×2
