8
UM TGMIC-021419
POWER & CONNECTIVITY
WARNING:
The TG Microphone does not use 48V phantom
power, be sure to disable preamplifier 48V phantom power
prior to connection. The TG Microphone relies on dedicated
power supply unit (PSU) system and specially wired cable;
only use the supplied Chandler Limited PSU system and as-
sociated components.
Based upon country of purchase, the PSU system supplied
with the TG Microphone is localized for regional AC power,
for either 110V or 220V (115/230V.) A TG Microphone sys-
tem purchased in a region where AC is 110V (115V) stan-
dard cannot be used in one that is 220V (230V,) unless the
voltage specific AC adaptor is used.
Microphone Input
Located on the PSU rear panel is a 4-pin female XLR recep-
tacle, connect the supplied 25’ (762cm) 4-pin microphone
cable from the microphone to the PSU via this jack.
WARNING:
Only use the specially wired Chandler Limited
supplied 4-pin microphone cable or risk damage to the TG
Microphone system.
Microphone Output
Located on the PSU rear panel is a standard 3-pin male XLR
connector, this output jack supplies microphone level signal
to an external microphone preamplifier of the engineer’s
choice; the TG Microphone’s output impedance is 200 Ohms.
Ac power
Prior to any connection to AC power or cycling on of AC
power, connect the supplied 4-pin XLR cable between the
PSU and the TG Microphone.
WARNING:
Do not disconnect the 4-pin XLR microphone
cable at either end, when the PSU is powered on.
Located on the rear panel of the PSU is an AC power adap-
tor receptacle, connect the supplied AC power adaptor to
this jack, and the AC power adaptor to a suitable AC outlet.
WARNING:
Do not leave the AC power adaptor connected
to an AC outlet without being plugged into the PSU for long
periods of time; only use a Chandler Limited supplied AC
Adaptor.
Power Switch
The master power switch is located on the front panel of the
PSU. Once all connections to and from the microphone and
the PSU have been made, press the master power supply
switch inward to activate AC power.
When proper power connectivity has been made and the
PSU has been cycled on, both the LED located on the front
panel of the PSU and one located inside the TG Microphone’s
head basket will illuminate.
OUTPUT
AV 18V
INPUT
PUSH
TG MICR
OPHONE POWER SUPPL
Y
ON
OFF
PO
WER
000001
Chandler Limited
TG MICROPHONE
MICR
OPHONE C
ABLE - 4 PIN XLR
MICR
OPHONE C
ABLE - 4 PIN XLR
OUTPUT
AV 18V
INPUT
PUSH
TG MICROPHONE POWER SUPPLY
ON
OFF
POWER
000001
Chandler Limited
TG MICROPHONE
MICROPHONE CABLE - 4 PIN XLR
MICROPHONE CABLE - 4 PIN XLR
OUTPUT
AV 18V
INPUT
PUSH
TG MICROPHONE POWER SUPPLY
ON
OFF
POWER
000001
Chandler Limited
TG MICROPHONE
MICROPHONE CABLE - 4 PIN XLR
MICROPHONE CABLE - 4 PIN XLR
OUTPUT
AV 18V
INPUT
PUSH
TG MICROPHONE POWER SUPPLY
ON
OFF
POWER
000001
Chandler Limited
TG MICROPHONE
MICROPHONE CABLE - 4 PIN XLR
MICROPHONE CABLE - 4 PIN XLR
