4
UM TGMIC-021419
IMPORTANT PROCEDURES &
QUICK START
Shock Mount
WARNING:
To fit the microphone through the shock
mount system without damaging the felt, over-flex the
mount’s latches by pushing them backwards or the opposite
direction of closing, until the suspension rings expand to a
width suitable to comfortably slip the microphone through
them head first.
Connections
1. WARNING:
Turn off any 48V phantom power from
external preamplifiers to be used with the TG Micro-
phone.
2. Connect the TG Microphone to the included power
supply unit (PSU) using the supplied 4-pin microphone
cable. Only use the Chandler Limited supplied cable,
power supply and AC adaptor.
3. Connect a standard 3-pin XLR microphone cable to the
TG Microphone’s PSU output jack and to the input of
a microphone preamplifier; remember to disable the
preamp’s 48V phantom power prior to connection.
4. Connect the TG Microphone’s power supply to the
supplied AC adaptor, and connect the AC adaptor to a
power outlet.
Power -up
1. Once all connections to and from the TG Microphone’s
power supply have been made, cycle on the power sup-
ply by means of the power switch located at the front
of the PSU.
2. If power has been achieved, the TG microphone’s
on-board LED, located inside the head-basket and the
LED on the PSU front panel will illuminate to signify the
microphone system is active; the LED inside the TG
Microphone head-basket is also used to help align the
capsule to the sound source.
3. WARNING:
Do not disconnect the 4-Pin microphone
cable while AC power is applied to the microphone. If
disconnection is to be made, power off the TG Micro-
phone’s PSU and wait for the power supply’s LED to
fully discharge before removing the 4-pin microphone
cable or AC power adaptor at either end.
NOTE:
The 3-pin XLR audio output connection may be
patched or unpatched as necessary, without powering
down.
Warm -up
It is recommended for all electronics—once powered on—
to be given time to settle before use. Though optional…for
optimum results, prior to sound incident or usage, allow the
TG microphone to warm-up for a minimum of 3-5 minutes.
Power Down
Prior to disconnecting the 4-pin cable between the micro-
phone and the PSU or AC power adaptor from the PSU and
or wall outlet, first power down the PSU, and wait for the
external PSU’s LED to fully discharge.
NOTE:
It is recommended to power down the TG Micro-
phone when not in use.
