Chapter 5
SAFETY FEATURES
[73]
11
MAINTENANCE
This chapter describes preventive and corrective maintenance for the 5000 Series Pump system. This
chapter includes:
•
Special Tools and Spare Parts Kit, Section 11.1
•
Changing the Cylinder Barrel Seals, Section 11.2
•
Maintaining the Pump Cylinder, Section 11.3
•
Cooling Fan Maintenance, Section 11.4
•
Replacing the Safety Rupture Disk, Section 11.5
•
Calibrating the Pressure Transducers, Section 11.6
•
Valve Maintenance, Section 11.7
NOTE:
For the purposes of this manual, the term “regular use” is defined as using the pump system 2
to 3 days per week, every week, at pressures above 35% of the rated pump pressure or at rates above
35% of the maximum pumping rate. If you are operating at lower pressures, very low rates, or
infrequently, then the stated service intervals can be increased. Some conditions may require servicing
the pump system more often.
CAUTION
As a general safety precaution, always verify that there is no pressure in the pump
before performing any service procedures. To accomplish this, open the valve
(typically the fill valve), which vents the system to atmosphere.
11.1 Special Tools and Spare Parts Kit
Each Quizix pump system is shipped with a set of special tools and a spare parts kit that you should use
to service your system. Stand–mounted systems have a tool box mounted on the stand where these tools
and spare parts are located. A description of the special tools is described in Table 11-1. The spare parts
kit is described in Table 11-2.
Table 11-1
Special Tool Kit
Item
Tool
Description
No.
1
1/2
–inch angled open–
end wrench
The 1/2 inch angled open-end
wrench is used to tighten the
Speedbite
®
fittings and is especially
useful for tightening the two ports on
the cylinder barrel.
Содержание Ametek Quizix 5000 Series
