If you require parts or service assistance, please call the
CHAMPION TRAPS AND TARGETS Customer Service Dept.
at (800) 379-1732
©
2015 CHAMPION TRAPS AND TARGETS, Anoka, Minnesota 55303
9
6. Assembling the Magazine
The magazine ships unassembled. The top and bottom magazine plates are shipped attached
to the Trap body (FIGURE 5). The magazine rods, stubs and screws are shipped in the
hardware carton inside the shipping box.
To Assemble the Magazine:
1. Remove the magazine index gear by first removing the retaining plate and the key
(FIGURE 9) using the E-7 hex wrench
2. Lift the top and bottom magazine plates off the trap body.
3. Separate the top and bottom magazine plates by removing the cardboard, protective
wrapping, and the wire ties that secure them to each other (FIGURE 5).
4. The magazine is assembled following the picture shown in figure 6.
NOTE:
When installing the eighteen (18) socket head cap screws that secure the inner and
outer magazine stubs on the bottom of the magazine assembly, gently tighten the screws until
they stop and turn them an additional 1/4 turn.
DO NOT OVERTIGHTEN!
Figure 5 – Magazine Plates Figure 6 – Assembling the Magazine
ITEM
DESCRIPTION
E-1.
Inner Magazine Rods – 6 ea
E-2.
Outer Magazine Rods – 12 ea
E-3.
Inner Magazine Stubs – 6 ea
E-4.
Outer Magazine Stubs – 12 ea
E-5.
Magazine Top Plate Screws – 18 ea
E-6.
Magazine Stub Screws – 18 ea
E-9.
Magazine Top Plate
E-10.
Magazine Bottom Plate
Wire Ties
E-1
E-2
E-3
E-4
E-5
E-6
E-9
E-10
Figure 7 –
Assembled
Magazine
