50
Troubleshooting
(Chinese)
SYMPTOM
CAUSE
SOLUTION
Motor does not start.
Body is not properly assembled to hub.
Check assembly.
Magnet in body flange is missing.
Replace magnet.
ON/OFF Switch is off.
Turn on switch.
Power supply is bad.
Check plug and circuit breaker.
Juicer motor bad.
Replace motor.
Proximity switch is bad.
Replace proximity switch.
ON/OFF Switch is bad.
Replace ON/OFF switch.
Motor stalls.
Feeding too much material too fast.
Feed material more slowly.
Auger worn.
Replace auger.
Restrictor worn.
Replace restrictor.
Juice/pulp slinging from restrictor.
Deflector not installed.
Install deflector.
Excessive or unusual noise.
Improper assembly.
Re‐assemble.
Part damage.
Replace damaged parts.
Excessive heat in juice or pulp.
Feeding too much material too fast.
Feed material more slowly.
Restrictor plugged.
Remove restrictor, clear blockage and replace.
Wrong restrictor installed.
Replace with recommended restrictor.
Auger worn.
Replace auger.
Restrictor worn.
Replace restrictor.
Leakage of juice at flange of body.
O‐ring missing.
Install o‐ring.
O‐ring damaged or worn.
Replace o‐ring.
Material backs up in feeding tube.
Feeding too much material and/or too fast.
Reduce rate of feeding.
Wrong restrictor installed.
Replace with recommended restrictor.
Restrictor is plugged.
Remove, clean and replace restrictor.
Replace grinding auger with the greens auger.
Low Yield
Material being juiced is dry.
Replace with fresh material.
Restrictor is missing.
Install restrictor.
Wrong restrictor installed.
Replace with recommended restrictor.
Nature of material being juiced.
Re‐feed material.