Champion 22 TON LOG SPLITTER, Руководство пользователя и инструкции по эксплуатации

Страница: 13 / 31

Assembly
Rev 92201-20090714 9
Add Engine Fuel
1. Use clean, fresh, regular unleaded fuel
with a minimum octane rating of 85.
2. DO NOT mix oil with fuel.
3. Clean the area around the fuel cap.
4. Remove the fuel cap
5. Slowly add fuel to the tank. DO NOT
overfill. Allow approximately ¼ inch of
space for fuel expansion.
6. Screw on the fuel cap and wipe away any
spilled fuel.
CAUTION
Use regular unleaded gasoline with a minimum
octane rating of 85.
DO NOT mix oil and gasoline.
Fill tank to approximately ¼” below the top of
the tank to allow for fuel expansion.
DO NOT fill fuel tank indoors.
DO NOT fill fuel tank when the engine is running
or hot.
DO NOT overfill the fuel tank.
DO NOT light cigarettes or smoke when filling the
fuel tank.
Add Hydraulic Oil
1. Make sure the log splitter is on a flat,
level surface.
2. Remove the oil cap from the oil tank.
3. Add 3.4 gallons of hydraulic oil - 10W
AW32, ASLE H-150, or ISO 32 are all
acceptable types of fluid.
4. Check the hydraulic oil level.
5. Start engine and use the control valve
handle to extend and retract wedge
several times to remove air from the
lines.
6. With the wedge retracted, check oil level
again. Fill if necessary.
WARNING
DO NOT remove the hydraulic oil fill cap when
the engine is running or hot. Hot oil can escape
causing severe burns. Always allow the log
splitter to cool completely before removing the
hydraulic oil cap.
High fluid pressure and temperatures are created
in the hydraulic log splitters. Hydraulic fluid will
escape through a pin-size hole opening and can
puncture skin and cause severe blood poisoning.
Inspect hydraulic system regularly for possible
leaks. Never check for leaks with your hand
while the system is pressurized. Seek medical
attention immediately if injured by escaping fluid.