201160 - 12,000W ELEcTRic START GENERATOR
ASSEMbLY
16
ASSEMbLY
Your generator requires some assembly. This unit ships from our
factory without oil. It must be properly serviced with fuel and oil
before operation.
If you have any questions regarding the assembly of your
generator, call our Technical Support Team at 1-877-338-0999.
Please have your serial number and model number available.
install the Wheel Kit
cAUTiON
The wheel kit is not intended for over-the-road use.
Install the Wheels
1. Make sure all items have been removed from the shipping
carton/pallet and double check for any items that may be in
the generator frame.
2. With the generator still on the pallet install the wheel.
3. Slide the wheel pin roll through the wheel from the outside.
4. Slide the wheel pin roll through the mount point on the frame.
5. Secure with the R-Pin.
6. Install wheel hub cap onto wheel.
7. Repeat steps 2-6 to attach the second wheel.
8. Remove wooden blocks from in front of the frame and the
support leg.
9. Raise handle and pull generator forward until wheels touch
the ground. Then pull generator out from wood pallet.
connect the battery
1. Cut cable tie on each side of battery connector.
2. Push two halves of battery connector together tightly.
Add Engine Oil
WARNiNG
DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the generator as a result of failing to follow these
instructions will void your warranty.
NOTicE
The generator rotor has a sealed, pre-lubricated ball bearing
that requires no additional lubrication for the life of the
bearing.
