100693 - 7500W ELECTRIC START GENERATOR
OPERATION
18
2. Press and hold the ignition switch to the “START” position.
Release as the engine begins to start. If the engine fails to
start within five seconds, release the switch and wait at least
ten seconds before attempting to start the engine again.
3. Do not over-choke. As soon as engine starts, move the choke
to the “RUN” position over a 2-5 second duration.
!
CAUTION
If the ignition switch is held down in the “START” position
longer than 5 seconds it could damage the starter.
Manual Start
1. Push the ignition switch to the “ON” position.
2. Move the choke to the “CHOKE” position.
2a. For restarting a warm engine, move the choke to 75% of
the “CHOKE” position.
3. Pull the recoil cord slowly until resistance is felt and then pull
rapidly.
4. Do not over-choke. As soon as engine starts, move the choke
to the “RUN” position over a 2-5 second duration.
"
NOTICE
Keep choke in “CHOKE” position for only 1 pull of the recoil
cord. After first pull, move choke to “RUN” position for up to
3 pulls of the recoil cord. Too much choke leads to spark plug
fouling/engine flooding due to lack of incoming air. This will
cause the engine not to start.
