9
REV 93520-20130425
ENGLISH
93520
ASSEMBLy
4) Install the Tow Bar Cont’d.
3. Install the front support leg and secure with pin and
R-pin (hairpin clip). (C)
C
C
5) Install the Beam Cont’d.
5) Install the Beam
1. Stand the beam upright on foot plate behind the
hydraulic oil tank. (A)
2. Slowly lift the front of the tow bar to roll the frame
toward the beam and carefully align the pivot holes
on the bottom of the beam and the top of the
hydraulic oil tank.
3. Once aligned, secure the beam to the tank with hitch
pin and R-pin. (B)
4. Hold the top of the beam by the cylinder mount and
carefully rotate the beam toward the tow bar.
The beam is very heavy and should only be moved
or lifted by at least 2 able persons at all times
during assembly process. Use extreme caution to
avoid injury.
WARNING
A
B
To
B
B
A
3. Install the cylinder by sliding the pegs at the end
of the cylinder into the mounting slots on top of the
beam. Be sure to slide the cylinder all the way back
into the mounting slots. (B)
4. Secure the cylinder mounting plates with hardware
removed in step 2. (B)
5. Slide the wedge back toward the cylinder and align
the bolt hole in the wedge with the bolt hole in the
cylinder rod. (B)
The cylinder will support itself when slid all the way back
into the mounting slots.
NOTE
6) Install the Cylinder and Wedge
1. Place the wedge on the beam between the cylinder
mounts and slide it forward into the rails. (A)
2. Remove the cylinder mounting plates. (A)
5. Once the bracket on the bottom of the beam is aligned
with the tow bar, secure the beam in the horizontal
position with pin and R-pin. (C)
The cylinder rod may need to be rotated slightly
in order to properly align the the wedge. Insert a
screwdriver into the bolt hole in the cylinder rod
and slowly rotate as needed.
NOTE
