100679 - 24 iN. 2-STAgE SNOwbLOwER
OPERATiON
20
OPERATiON
wARNiNg
Never use the snowblower without first reading and
understanding the operating instructions, warnings and
instruction labels located on the machine.
before Operation
–
Check the General Condition.
–
Look around and underneath the engine for signs of oil or
gasoline leaks.
–
Remove any excessive dirt or debris, especially around the
muffler and recoil starter.
–
Look for signs of damage.
–
Check that all shields and covers are in place, and all nuts,
bolts, and screws are tightened.
Check the Engine
1. There is no fuel or oil in the engine. Fill with fuel and add
0W-30 prior to first use.
2. Check the fuel level (see
Add Fuel
under
Assembly
section).
3. Check the oil level (see
Add Engine Oil
under
Assembly
section).
wARNiNg
Always check the engine oil level before operation. Using the
snowblower without oil can seriously damage the engine and
void your warranty. The machine must stand on level ground
when checking.
Engine key and throttle lever plastic piece need to be attached
before first use. These parts may be attached to the recoil
starter grip. Please remove the key and throttle lever from the
recoil starter grip and attach/install properly.
wARNiNg
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in objects
being thrown into your eyes and other possible serious injuries.
Starting the Engine
1. Make sure the engine key (safety lock out) is inserted into the
key hole.
2. To start a warm engine: (Fig. 14).
2a. Move the fuel valve lever to the ON position.
2b. Move the choke lever to the RUN position.
2c. Move the throttle lever to full speed.
2d. Do not prime.
CHOKE
FULL SPEED
FUEL OFF
FUEL ON
RUN
Figure 14
3. To start a cold engine: (Fig. 15).
3a. Move the fuel valve lever to the ON position.
3b. Move the choke lever to the CHOKE position.
3c. Move the throttle lever to full speed.
3d. Prime 3-5 times.
CHOKE
FULL SPEED
FUEL OFF
FUEL ON
RUN
Figure 15
