6
100398
ENGLISH
ASSEMBLY
Figure 9 - Pitch Adjustment Bolt (spring not shown for clarity)
Figure 12 - Tube System Attachment
Figure 11 - Blade Rotation Angle
Figure 11-A - Blade Rotation Angle
Figure 10 - Spring Adjustment
Default
11
15.7
15.6
11
3/4” DEFAULT
15.12
15.9
15.11
7 . Decide desired pitch of blade . Each hole allows 5
degrees of blade pitch adjustment .
Push Tube Assembly and Installation Cont’d.
Push Tube Assembly and Installation Cont’d.
Figure 9 shows the default position .
NOTE
Make sure handle is locked in before plowing .
NOTE
For each
1
⁄
4
in . (6 .4 mm) that the nut is tightened
it will add 7 lbs (3 .2 kg) of spring tension . This will
make a total of 14 lbs (6 .4 kg) with both springs .
NOTE
8 . With springs installed and pitch blade under tension,
install
3
⁄
4
in . (19 .1 mm) hex socket head cap screw
(15.7)
using
3
⁄
8
in . (9 .5 mm) Allen wrench or pliers;
and
7
⁄
16
in . (11 .1 mm) lock nut
(15.6)
into desired
pitch position hole . As shown in Figure 9 .
9 . Tighten nuts down on eye bolt until desired spring
tension is reached . See Figure 10 for default
tension .
10 . The tube system has five positions of rotation for
your blade . Each adjustment is a 12 .5 degree
increment . To adjust, push down on the handle
(Figure 11-A, Item 11) and rotate your blade left or
right until you reach the desired angle .
11 . Attach the tube system to the Hybrid Mount System,
by first positioning the tube system, with blade
installed, under your ATV . Then raise tube attach
points to the mount and line up the holes on mount
plate with the holes in the tube system . Insert Pin
through holes and secure on other side with clips as
shown in Figure 12 .
3/4 in. (19.1 mm)
default