100520 - 8750W PORTABLE INVERTER GENERATOR
CONTROLS AND fEATURES
12
Control Panel
1.
Ignition Switch
– Used to put in START mode or STOP the
generator.
2.
Economy Mode Switch
– Enables/disables automatic idle
control.
3.
Choke
– Used to start a cold engine.
4.
Intelligauge
– Four mode digital meter for displaying voltage,
frequency (hertz), run time, and total run time.
5.
Output Indicator Light
– Remains ON during normal
operating conditions. Turns OFF when generator is
overloaded.
6.
Overload Indicator Light
– When ON generator is overloaded
and power to receptacles is cut.
7.
Oil Warning Indicator Light
– When ON engine will shut
down and not run. Check oil level.
8.
AC Overload Reset Button
– Used to re-energize
receptacles after overload fault.
9.
Circuit Breakers (Push Reset)
– Protects the generator
against electrical overloads.
RECEPTACLES
A
z
12V DC, 8 Amp (Automotive)
May be used to supply electrical power for
operation of 12 Volt DC, 8 Amp electrical loads.
B
C
(4×) 120V AC, 20A GFCI (NEMA 5-20R)
May be used to supply electrical power for
operation of 120 Volt AC, 20 Amp, single phase,
60 Hz electrical loads.
C
Y
120/240V AC, 30A Locking (NEMA L14-30R)
May be used to supply electrical power for
operation of 120/240 Volt AC, 30 Amp, single
phase, 60 Hz electrical loads.
WARNING
Do not operate a device while it is plugged into the 12V DC
outlet. Prolonged exposure to engine exhaust can cause
serious injury or death. While charging a device do no place
on the exhaust side of the generator. Extreme heat caused by
exhaust can damage the device, and cause a potential
fire hazard.
1
3
9
8
9
5
6
7
4
2
C
A
B
