Champion Autolift FP8000, Руководство по установке

Страница: 9 / 14

Check the crossrail locking assembly before use. Make sure all bolts and
collars are tight. The assembly is pre-installed from the factory but parts
may come loose during shipping.
After installation is completed, before start up, be sure to inspect and
tighten all bolts.
Start Up:
​
Make sure power unit reservoir is full with 12 quarts of 10-wt hydraulic
oil and spray the inside of the columns where the slide blocks glide with a light
lubricant.
2) If you are not familiar with electrical hooks, it is best to call a certified
electrician. Check inside the switch box to make sure you use the correct
colored wire for ground. Also, check the outside plate to make sure your
motor is the proper voltage. Your motor will be for 110 volts unless you
specifically ordered a 220 volt motor.
Initial Operation:
​
Press the UP SWITCH on the power unit. Raise the lift slowly
until all the slack in the cables is taken out. Raise the lift until the safety latch
closest to the power unit comes within 1” to the bottom of the lowest lock
position. Tighten the cable-adjusting nut on top of each leg cap until all
remaining safety latches come within 1” to the bottom of the lowest lock
position. If cables are adjusted evenly the lift should be raising level and all four
safety latches engage or audibly click simultaneously.
IF LIFT DOES NOT RISE:
​
Check hose connections. Fluid should be pumping
through the hose. Check fluid level.
NOTE:
​
There will be some initial stretching of the cables in the beginning. It will
be necessary to readjust the cables a week or so after first use.
Run the lift up and down a few times to make sure that the safety latches is
engaging uniformly and that the safety latch release is functioning properly.
Re-adjust if necessary.
When lowering the lift
​
PAY CAREFUL ATTENTION. ALWAYS
​
make sure that all
FOUR SAFETY LATCHES
​
are disengaged. If one of the latches locks on
descent
​
STOP
​
immediately and raise until it is clear of the stop and adjust the
hemin on that latch.
Install the approach ramps on the entry side of the lift. Drive a vehicle onto the
lift tracks then install the rear wheel chocks. Run the lift up and down a few
times to insure that the latches are engaging uniformly and that the safety latch
release is functioning properly. Re-adjust if necessary.
9