Champion Autolift FP8000, Руководство по установке

Страница: 7 / 14

brackets, wheel stops with
​
1/2” x 4” bolts and nuts
​
. After both tracks are
installed, tighten all bolts 1/2” x 4” bolts - torque - 45 ft-lbs.
Find the leg caps
​
(4 each), 1/2” x 7” bolts (4 each), 1/2” x 1 1/4” bolts (4
each), 1/2” nuts (8 each) and 1/2 “ flat washers (16 each),
​
holes for cable
face towards the center of the lift. Secure the leg caps with
​
1/2” x 1 1/4” bolts
​
.
Place the bolts with washers in through channel and secure with washers and
nuts on the outside of the leg. Install the
​
1/2” x 7
​
” bolts through the leg and top
cap. Install from outside of the leg, and secure with a nut on the inside of the
leg. Tighten the
​
1 1/4” bolt
​
. Tighten the 7” bolt to a torque of 45 ft-lbs. Do not
over tighten the
​
7” bolt
​
, as this may warp the column channel and bind the
guide blocks.
1)
​
The cables are already strung and ready to attach to the top of legs. Before
doing this you must extend the chrome rod out of the cylinder far enough for the
cables to reach. If you have the lift on the lowest lock you will need to extend
the cable approximately 60 inches.
DO NOT USE THE POWER UNIT TO EXTEND THE CYLINDER
Make sure both parts on the cylinder are open to allow the easy flow of air.
Manually or with a device such as a come along, pull the cylinder out 60 inches.
Although the cylinder may be difficult to move at first, it is usually much easier
once you get the first movement.
If you have a compressor you can use air to extend the cylinder. Place the air
Into the back port, (the port away from the chrome rod) and blow air into the
cylinder.
7