4
D.
Outdoor Wall mount kit and L-type Bracket installation(optional)
1.
Position the L-type at the desired installation location. Drill two holes into the placement and hammer the
included screw anchors.
2.
Align the two holes on the L-type bracket to the two plastic anchors on the wall or ceiling, insert the supplied
screws to the corresponding hole and fix them.
3.
Assembly silicone rubber and outdoor kit together.
4.
Combine O-ring and supplied screws(M4x10) together, secure the outdoor kit to the L-type bracket with
combination screws.
5.
Feed the cables through conduit hole A or B. If you want to use hole A, remove the plug with a screwdriver.
Thread the network and I/O cable through thread-lock sealing nut, claw (using the claw to round all cable)
and cable gland. To seal all cable in the claw part tightly in case of water leaking. Attach the cable gland to
the conduit hole. Push the claw into the cable gland and tighten thread-lock sealing nut to secure the cables.
Then, secure the camera to the outdoor kit with screws (M2.5x6 * 2pcs)
6.
Paste the waterproof-tape at microphone hole on the top cover.
7.
Adjust the angle of camera to aim the shooting area.
Conduit hole B
Conduit hole A
Note: Once waterproof sticker is pasted on top
cover for outdoor used, microphone reception
will be affected.
