Chamiin I&C 0024-1236, Инструкция по эксплуатации и техническому обслуживанию

Страница: 9 / 18

Portable Bluetooth Printer Description
Instruction Handy700-BT
３
Sensors
There are three sensors that perform the following functions:
• Paper Cover: When the paper cover is open the printer is disabled to prevent
damage to the print head. This condition is indicated by the Power LED
flashing.
• Paper Out: When the paper roll runs out, the printer is disabled to prevent
damage to the print head. This condition is indicated by the Power LED
flashing.
• IrDA: Located at the front of the printer, this sensor accepts the infrared signal
from the instrument.
Figure 1. Component Locations and Functions
Power / Error (Green) LED:
1) Glows steady when printer is turned
ON.
2) Flashes when printer is out of paper;
when paper cover is open ; or when
print head temp. is above 140 °F.
Battery (Orange) LED:
1) Glows steady when battery pack is
being charged.
2) Off when battery is fully charged.
Bluetooth (Blue) LED:
1) Connected: Off.
2) Disconnect or try to connect: Flashing.
IrDA Sensor
FEED Pushbutton:
1) With printer already ON, press to
advance paper.
2) With printer in its Set-Up Mode, press to
change value of printer parameter as
chosen by the SEL button.
3) Hold down and turn printer ON to enter
Self-Test Mode.
SEL Pushbutton:
1) Hold down and turn printer ON
to enter Set-Up Mode.
2) Once in Set-Up Mode, Press to
change printer parameter.
Power
OFF ON
Battery Cover
Paper Cover
Power Connector RS-232C Connector