6
1
4
2 3
Manual Limit setting
With the door in the midway position.
• Press and hold the black button until the orange
LED starts flashing.
• Use the black (up) and purple (down) button to set
the door opening limit
• Press the Green activation button to start the door,
once it starts travelling down, press either the black
or purple button to engage manual limit setting.
•
Use the purple and black buttons to set the closing
limit.
• Test door three or four times to check limit settings.
Setting the Limits
Up limits regulate the points at which the door
will stop when moving up or down. Follow the
steps below to set the limits.
• Check that the opener is engaged and midway
between open and closed.
To program the travel limits:
• Press and hold the BLACK button (3) until the
orange indicator light (2) starts flashing slowly and
then release. Opener lights will dim. Press the
BLACK button to move the door UP or the PURPLE
down button to move the door DOWN until the door
reaches the desired UP limit.
Check to be sure the door is high enough for your
vehicle. Adjust if necessary.
• Press the GREEN start button (4). This sets the full
UP limit. The door will travel to the floor and reverse
back to the UP limit. The opener has learned its
limits.
• The indicator light (2) will stop flashing when the
limits have been learned.
NOTE: If the door presses excessively on the floor or
reverses before it reaches the floor use the Manual
Limit setting option:
The force must be learned in order to properly
complete the setting of the limits.
11
Program your Opener & Remote
Please note your remote controls and wall plate
have already been programmed into your operator.
Activate the opener only when door is in full view,
free of obstruction and properly adjusted. No one
should enter or leave garage whilst door is in
motion. Do not allow children to operate push
button(s) or remote(s). Do not allow children to
play near the door.
Fix any wall control at a height of at least 1.5m and
within sight of the door but away from any moving
parts.
• Fix the warning against entrapment label near the
wall control.
• ADDING remotes using the PURPLE “learn”
Button
• Press and release the PURPLE “learn” button on the
opener. The orange indicator light will glow steadily
for 30 seconds.
• Within 30 seconds, press and hold the desired button
on the wireless wall control or remote control that you
wish to operate your garage door.
• Release the button when the opener light blinks. It
has learned the code.
DELETE all Remote Control Codes
Please note this deletes all remotes and codes
Press and hold the PURPLE learn button until the
orange indicator light goes out (approximately 9 sec).
10
or
m
meerrlliinn
++
