Chamberlain LiftMaster CSW200UL Series, Руководство пользователя

Страница: 37 / 56

35
OFF ON
buIlT-IN REsET swITch
AudIO AlARM
When the gate operator’s audio alarm (see below) has been tripped, the reset switch must be
pushed for the operator to function again.
The reset switch will shut off an activated audio alarm and reset the operator to function again.
If the audio alarm goes off, always check the gate area for:
• Obstructions in the gate path.
• Damage to the gate and/or gate operator.
The operator arm or gate
is incorrectly installed.
horizontal Level
Vertical
Level
The gate is TOO heavy. An externally wired photoelectric sensor has been
triggered twice (photoelectric sensor blocked).
Gate hinges are too tight or broken and
the gate is not moving freely.
The gate hits the driveway, curb or other, and
gets stuck or bent in an awkward position.
The gate is moving and a car pushes the
gate.
A foreign object is on the gate frame while
the gate is moving.
Press the built-in reset switch to shut off alarm and reset operator (see above).
Incorrect Incorrect
Pressing the reset switch will stop a moving gate during a
normal open/close cycle, like a stop button. The operator
does NOT need to be reset after doing this.
The alarm could be tripped when one of the following happens twice consecutively,
then the alarm will sound for 5 minutes or until the reset switch is pressed!