33
Operation
Features
Your garage door opener is equipped with features to provide you with greater control over your
garage door operation.
MyQ
®
MyQ
®
technology uses a 900MHz signal to provide two-way communication between the garage door
opener and MyQ
®
enabled accessories. Your garage door opener is compatible with up to 8 MyQ
®
accessories. For Smartphone App control of your garage door opener and other MyQ
®
accessories,
Chamberlain's MyQ
®
Internet Gateway (model CIGBU) is required.
TIMER-TO-CLOSE (DO NOT enable on one-piece doors)
The Timer-to-Close feature is not available on all door controls. Below is a list of door controls with the
Timer-to-Close feature:
041A7305-1 Smart Control Panel and 041A7327-1 Motion Detecting Control Panel
The Timer-to-Close feature automatically closes the garage door after a specified time period.
DO NOT
enable TTC if operating a one-piece door. TTC is to be used ONLY with sectional doors.
Factory
default is set to off. The garage door opener will beep and the lights will flash before closing the door.
The TTC feature will deactivate if the garage door encounters an obstruction twice; or the safety
reversing sensors are incorrectly installed. The garage door will reverse open and WILL NOT close
until the obstructions are clear or the safety reversing sensors are correctly installed. When the
obstruction has been cleared or the safety reversing sensors have been aligned, the door will close
when the garage door opener is activated. TTC WILL NOT work if the garage door opener is operating
by battery power or if the safety reversing sensors are misaligned. This feature is NOT intended to be
the primary method of closing the door.
A keyless entry should be installed in the event of an
accidental lock out when using this feature.
REMOTE CONTROLS AND DOOR CONTROLS (MyQ
®
)
Your garage door opener has already been programmed at the factory to operate with your remote
control, which changes with each use, randomly accessing over 100 billion new codes. Compatible with
MyQ
®
enabled accessories, see page 41.
NOTE:
Older Chamberlain remote controls, door controls, and third party products are not compatible.
MyQ
®
Accessories
MEMORY CAPACITY
Remote Controls
Up to 8
Door Controls
Up to 2 MyQ
®
door controls
Keyless Entries
Up to 1
THE PROTECTOR SYSTEM
®
(SAFETY REVERSING SENSORS)
When properly connected and aligned, the safety reversing sensors will detect an obstruction in the
path of the infrared beam. If an obstruction breaks the infrared beam while the door is closing, the door
will stop and reverse to full open position, and the opener lights will flash 10 times. If the door is fully
open, and the safety reversing sensors are not installed, or are misaligned, the door will not close from
a remote control. However, you can close the door if you hold the button on the door control or keyless
entry until the door is fully closed. The safety reversing sensors do not effect the opening cycle.
ENERGY CONSERVATION
For energy efficiency the garage door opener will enter sleep mode when the door is fully closed. The
sleep mode shuts the garage door opener down until activated. The sleep mode is sequenced with the
garage door opener light bulb; as the light bulb turns off the sensor LEDs will turn off and whenever the
garage door opener lights turn on the sensor LEDs will light. The garage door opener will not go into
the sleep mode until the garage door opener has completed 5 cycles upon power up.
LIGHTS
The garage door opener light bulbs will turn on when the opener is initially plugged in; power is
restored after interruption, or when the garage door opener is activated. The lights will turn off
automatically after 4-1/2 minutes. An incandescent A19 light bulb (100 watt maximum) or for maximum
energy efficiency a 26W (100W equivalent) compact fluorescent light (CFL) bulb may be used.
NOTE:
Do not use halogen, short neck, or specialty light bulbs as these may overheat the end panel or light
socket. Do not use LED bulbs as they may reduce the range or performance of your remote controls.
Light Feature
The garage door opener is equipped with an added feature; the lights will turn on when someone
enters through the open garage door and the safety reversing sensor infrared beam is broken. For
added control over the light bulbs on your garage door opener, see page 34.
