27
Using the Wall-Mounted Door Control
Press the push bar/button to open
or close the door. Press again to
reverse the door during the closing
cycle or to stop the door while it's
opening.
THE MULTI-FUNCTION DOOR CONTROL
Light feature
Press the Light button to turn the opener light on or off.
It will not control the opener lights when the door is in
motion. If you turn it on and then activate the opener, the
light will remain on for 4-1/2 minutes. Press again to turn
it off sooner. The 4-1/2 minute interval can be changed to
1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold
the Lock button until the light blinks (about 10 seconds).
A single blink indicates that the timer is reset to 1-1/2
minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat again
for a 3-1/2 minute interval, etc., up to a maximum of four
blinks and 4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from
hand-held remote controls. However, the door will open
and close from the Door Control, the Outside Keylock and
the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds.
The push bar light will fl ash as long as the Lock feature is
on.
To turn off, press and hold the Lock button again for
2 seconds. The push bar light will stop fl ashing. The Lock
feature will also turn off whenever the “Learn” button on
the motor unit panel is activated.
Additional features when used with the
3-Button hand-held remote
A) To control the opener lights:
In addition to operating the door, you may program the
remote to operate the lights.
1. With the door closed, press and hold a small remote
button that you want to control the light.
2. Press and hold the Light button on the Multi-Function
door control.
3. While holding the Light button, press and hold the
Lock button on the door control.
4. After the opener lights fl ash, release all buttons.
To Open the Door Manually
The door should be fully closed
if possible. Pull down on the
emergency release handle and lift
the door manually. To reconnect
the door to the opener, press the
door control push button.
The
lockout feature
prevents
the trolley from reconnecting
automatically, Pull the emergency
release handle down and back
(toward the opener). The door
can then be raised and lowered
manually as often as necessary.
To disengage the lockout feature,
pull the handle straight down. The
trolley will reconnect on the next
UP or DOWN operation.
To prevent possible SERIOUS INJURY or DEATH from
a falling garage door:
• If possible, use emergency release handle to
disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced
door could result in an open door falling rapidly and/
or unexpectedly.
• NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If
rope knot becomes untied, you could fall.
LOCKOUT POSITION
Trolley
Release
Arm
Emergency
Release
Handle
(Down and Back)
MANUAL DISCONNECT
POSITION
Trolley
Release
Arm
Emergency
Release
Handle
(Pull Down)
Push
Bar
Push
Button
Lock
Button
Light
Button
B) To operate one door using all three
buttons on the hand-held remote:
You may program the remote to open
the door with the large button, close it
with the middle button, and stop the
door’s movement with the third button.
NOTE:
If remote is already programmed, you must fi rst
erase all codes. See Programming.
1. With the door closed, press and hold the large remote
push button.
2. Press and hold the Lock button on the door control.
3. Press and hold the door control push bar.
4. After the opener lights fl ash, release all buttons.
Open
Stop
Close
