Chamberlain 3595LM 3/4 HP, Руководство пользователя

Страница: 11 / 36

11
INSTALLATION STEP 5
Hang the Opener
Three representative installations are shown. Yours may
be different. Hanging brackets should be angled (Figure 1)
to provide rigid support. On finished ceilings (Figure 2 and
Figure 3), attach a sturdy metal bracket to structural
supports before installing the opener. This bracket and
fastening hardware are not provided.
1. Measure the distance from each side of the motor unit
to the structural support.
2. Cut both pieces of the hanging bracket to required
lengths.
3. Drill 3/16" pilot holes in the structural supports.
4. Attach one end of each bracket to a support with
5/16"-18x1-7/8" lag screws.
5. Fasten the opener to the hanging brackets with
5/16"-18x7/8" hex bolts, lock washers and nuts.
6. Check to make sure the rail is centered over the door
(or in line with the header bracket if the bracket is not
centered above the door).
7. Remove the 2x4. Operate the door manually. If the door
hits the rail, raise the header bracket.
8. Grease the top and underside of the rail surface where
the trolley slides with rail grease.
NOTE: DO NOT connect power to opener at this time.
To avoid possible SERIOUS INJURY from a falling garage door
opener, fasten it SECURELY to structural supports of the
garage. Concrete anchors MUST be used if installing any
brackets into masonry.
WARNING
CAUTION WARNING
WARNING
Meas u re
Distance
Lag Scre w s
5/16"-1 8 x1-7/ 8 "
Str u ct u ral
S u pports
Bracket
(
N ot Pro v ided)
Lag Scre w s
5/16"-1 8 x1-7/ 8 "
( N ot Pro v ided)
Bolt 5/16"-1 8 x7/ 8 "
Lock W asher 5/16"
Nu t 5/16"-1 8
FINISHED CEILING
Hidden
S
u pport
Bolt 5/16"-1 8 x7/ 8 "
Lock W asher 5/16"
Nu t 5/16"-1 8
Bolt 5/16"-1 8 x7/ 8 "
Lock W asher 5/16"
Nu t 5/16"-1 8
Lag Scre w s
5/16"-1 8 x1-7/ 8 "
( N ot Pro v ided)
Bolt 5/16"-1 8 x7/ 8 "
Lock W asher 5/16"
Nu t 5/16"-1 8
FINISHED CEILING
Bolt 5/16"-1 8 x7/ 8 "
Lock W asher 5/16"
Nu t 5/16"-1 8
Figure 1
Figure 2
Figure 3
Lag Scre w 5/16"-1 8 x1-7/ 8 "
Hex Bolt
5/16"-1
8 x7/ 8 "
Nu t 5/16"-1 8
Lock W asher 5/16"
HARDWARE SHOWN ACTUAL SIZE