Challenger Lifts SX14, Инструкция по установке, эксплуатации и обслуживанию, Страница: 18 / 46

18
15)
Ensure power to supply wiring is OFF
before making following connections.
16)
Power supply to console shall be a suitable
electrical source as shown in the
Fig. 13 -
Electrical Wiring Diagram. For single phase
console, connect the electrical supply to the
back side of the Disconnect Switch, Refer
to
Fig. 13 . Note: the manual operated
service disconnect switch is a 3 pole switch,
only 2 of the 3 poles will be used. Connect
the ground wire to the GREEN contactor
beside the Disconnect Switch. Refer to
Fig.
13 for 3 phase console wiring.
H
YDRAULIC
C
ONNECTIONS
17)
Route hydraulic lines thru opening in the
bottom rear of the console.
18)
Connect the hydraulic lines to the block
connections inside the control unit,
Fig. 6 .
NOTE: The hydraulic lines from the lift
platforms can connect to either port.
Fig. 6 – Hydraulic Connections
P
NEUMATIC
C
ONNECTIONS
19)
The air lines from the lift can be identified
using the following table. Connect each air
line according to
Fig. 7 .
20)
IMPORTANT: Before air supply is
connected, ensure the T-fitting on the side
of the platform is plugged. The fitting is
used for the Rolling Jack Airline Kit
(40230-SX).
Description Line
LOCKS 6mm
ROLLING JACKS 10mm
SLIP PLATES
(AIR SUPPLY)
8mm
SLIP PLATES
(AIR LINE AT “Y”)
6mm
SEND CIRCUIT
(AIR LIMIT SWITCH WHITE PUSH LOCK)
4mm
RETURN CIRCUIT
(AIR LIMIT SWITCH RED PUSH LOCK)
4mm
SUPPLY AIR CONNECTION
Barb for 3/8 I.D
Hose
PRESSURE SWITCH
(WIRED NORMALLY CLOSED)
AIR VALVE
(NORMALLY OPENED)
Fig. 7 – Pneumatic Connections