14
Customer Helpline
01904 727503
www.gardenservicecentre.co.uk
Operating the Chainsaw
Step 1 - Start the engine
1a Engage the chain-brake (push it forward until an audible click is heard).
1b Set the switch to the “START” position.
1c Press and release the primer bulb (B) 10 times and ensure that the primer bulb is
approximately 3/4 filled with fuel before attempting to start.
Pull the choke control (A) out to engage.
1d While holding the saw unit securely on the ground, pull the start handle four times. at this
point, the engine will usually not start.
1e Push the choke control in to disengage. (failure to do this may cause the engine to flood).
1f Pull the start handle with smooth, continuous pulls no more than five times. If the engine does
not start, remove the spark plug, dry it with paper towel and replace. Repeat the start procedure.
1g Allow the saw to run and warm up in this position for 30 seconds.
1h. Disengage the chain-brake, by pulling it back.
NOTE!
If you fail to start your machine or require further assistance, please contact our after
sales support team at 01904 727503 .
- When restarting immediately after stopping the engine or when the engine is warm, it will not be
necessary to use the choke function.
Make sure the cutting blade is pointing away from your body at all times, the chain may rotate
upon ignition.
B
A
switch
WARNING!
Do not start the engine whilst holding the chainsaw in one hand. The saw chain may touch your
body. This is very dangerous.
