Challenge MEDALIST 820, Инструкция и каталог запасных частей

Страница: 9 / 80

9
F.669-D/820-870/Jan 98
(fig. 7)
side frames. Install the feed table so the notches in the
side brackets, (fig. 7), mate with the mounting pins in-
side the folder side frames.
NOTE: Mounting pins should be located in the upper
set of threaded holes. (Lower holes are used to mount
a crossfold carrier assembly.)
(fig. 8)
5. Install the stacker table assembly, (fig. 8), on the
back of the folder. Insert the spring-loaded end (right
side – viewed from rear of the folder) of the drive shaft
into the locator hole in the side frame, compress the
spring against the side frame and swing the opposite
end into position in the other side frame.
(fig. 9)
6. To pile folded materials, insert ears of stacker tray
into end of stacker table, as shown, fig. 9.
(fig. 10)
7. Attach the stacker wheel assembly to the tie bar
next to the jam detector, as shown, fig. 10.
(fig. 11)
8. Using two people, position the compressor on the
bottom shelf of the stand, (fig. 11).
(fig. 12)
9. Install the strainer screen (shipped with the acces-
sory kit) to the intake opening of the blower unit, (fig.
12).
Left Side
Locator
Hole
Locating Pins/
Feeder Notch