ORIGINAL INSTRUCTIONS
ORIGINAL INSTRUCTIONS
For easier operation and longer life, lubricate
the cutting blades before and after each use.
Before lubricating, make sure your hedge
MAINTENANCE AND
CARE
Make sure that the hedge trimmer has been
thoroughly cleaned before storing it in a clean
dry place out of the reach of children.
Always fit the transportation blade guard when
storing the hedge trimmer
trimmer is disconnected from the mains
supply.
Apply the oil so that it runs between the two
blades. (See Fig.E)
Fig.E
STORAGE
Electric Hedge Trimmer
Electric Hedge Trimmer
Model No.
Voltage
Power input
Cutting length
Max. cutting capacity
Protection class
Machine Weight
SPECIFICATIONS
HTEG34C-450
AC 230-240V,50Hz
400w
410mm
16mm
class II
2.51KG
A weighted sound pressure
A weighted sound power
Typical weighted vibration
NOISE INFORMATION
77.3dB K=3dB
97.3dB K=3dB
3.428m/s
2
K=1.5m/s
2
WARNING!
The vibration emission value during actual use of the power tool can differ form the declared value
depending on the ways in which the tool is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials is cut or drilled.
The tool being in good condition and well maintained.
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand vibration syndrome if tie use is not adequately managed.
PLUG REPLACEMENT
Your hedge trimmer is fitted with a moulded plug. However if you need to replace a fitted plug then
follow the instructions below.
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Blue - Neutral Brown – Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows.
The wire which is coloured blue must be connected to the terminal which is marked with N
The wire which is coloured brown must be connected to the terminal which is marked with the letter L
If a 13AMP (BS1363/A) plug is used, a 13A fuse must be fitted, or if any other type of plug is used a
13AMP fuse must be fitted, either in the plug or adapter, or on the distribution board.
Note:
If a moulded plug is fitted and has to be removed take great care in disposing of the plug and
severed cable, it must be destroyed to prevent engaging into a socket.If the supply cord is damaged
it must be replaced by a service agent or a similarly qualified person in order to avoid hazard.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
Cable grip
Brown L (live)
13 Amp fuse approved
to BS1362
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist.
Check with your local authority or retailer for recycling advices.
