Challenge Champion 305 XD, Техническое обслуживание и каталог запчастей

Страница: 17 / 138

3.0 Maintenance Guide
17
down arrow keys. When finished, choose D), to exit and go to the minimum pressure
set up seen shown below:
d. Setting the Minimum Pressure: Perform a cut cycle, after the clamp has contacted
the table and while the knife bar is coming down, read the pressure on the right hand
pressure gauge. It should be set at 400 p.s.i. If not, correct by using the up and
down arrow keys. When finished, choose C), to return to the Send mode, or D) Exit to
return to Diagnostics.
3.1.5 Clamp Cylinder
If the clamp piston bottoms in the cylinder before the clamp makes contact with the table, or if the
clamp does not make full travel on the up stroke, the clamp cylinder may need adjustment. The
clamp cylinder is located inside the left base casting leg behind the left front door (Figure 11, on page
18).
5.000
Set Maximum
>
Press /\ to Increase
Press \/ to Decrease
A) Main
C) Send
B) Job D) Exit
5.000
Set Minimum
>
Press /\ to Increase
Press \/ to Decrease
A) Main
C) Send
B) Job D) Exit
Clamp
Cylinder