Challenge Champion 305 XD, Техническое обслуживание и каталог запчастей

Страница: 101 / 138

5.0 Schematics & Parts Lists
101
5.33 Description of Error Messages
Message Description Test
Backgauge Failure
Backgauge doesn’t move
Mechanical bind; encoder failure;
main pc board; blown fuse
Backgauge at Limit Backgauge is all the way forward or
backward
Checksum Error Bad program chip Replace EEPROM
Clamp Up Failure Clamp failed to return to up position
within 7 seconds Clamp up sequence valve;
solenoid (cut) valve
Clamp Down Failure Clamp failed to come down Solenoid valves; low pressure;
low voltage
Clamp or Knife Down Clamp or knife stayed downs No main pressure; stuck solenoid
valve
Cut Relay Error 1 Cut relay energized when it should
be off Cut relay is stuck
Cut Relay Error 0 Cut relay de-energized when it
should be energized Output may be bad
DATA IS OUT OF RANGE The number is outside the limits of
the machine Informational error
Hydraulic Latch Failure 1 Latch relay was OFF when it should
have been ON Defective relay
Hydraulic Latch Failure 0 Latch relay was ON when it should
have been OFF Defective relay
Key is Invalid in Graphics Mode Tried to delete or insert a cut in an
auto-programmed job Information error
Knife Latch Failure 1 Latch prox. ON when it should have
been OFF Loose solenoid wire; mechanical
bind; knife up prox. Switch out of
adjustment; defective prox.
Switch
Knife Latch Failure 0 Latch prox. OFF when it should
have been ON
Knife Down Failure Knife failed to come down within 4
seconds Low main pressure; low voltage;
knife down sequence valve
Knife Up Failure Knife failed to return within 1.17
seconds Mechanical bind; solenoid (cut)
valve
Knife at Both Limits Knife up and down prox. Switches
are on at the same time Prox. Switches; broken knife bar
components
Lubricate Machine Lubricate machine alarm Have machine lubricated
Memory Failed A memory error occurred during
test
Memory Locked Tried to change a locked channel
Motor Starter Error 1 Motor starter engaged when it
should not have been Starter stuck
Motor Starter Error 0 Motor starter disengaged when it
should not have been Output may be bad
Next Channel Locked Tried to link two channels together
and the linked channel is locked
No Finish > Parent While entering sheet division data,
the sheet dimensions were greater
than the starting sheet