11
10
Customer Helpline
0845 450 5299
www.gardenservicecentre.co.uk
Customer Helpline
0845 450 5299
www.gardenservicecentre.co.uk
Operating the Hedge Trimmer
Step 4 - Trimming (continued)
Operating the Hedge Trimmer
Step 2 - Starting the Engine (continued)
5) Pull the starter grip again until the engine runs, let it run for about 15 seconds then operate this
hedge trimmer.
ATTENTION!
Do not pull too much; watch the movable knife.
2b Starting under warm conditions
1) Set the switch (
A
) to (START).
2) Set the choke lever to ( ).
3) Pull the starter grip (
B
) quickly until engine runs.
Always start with the sides. Guide the hedge trimmer along an arch route up and down and keep
cutting. You should be using both knife sides.
When cutting hold the hedge trimmer at the angle of about 15° and guide it horizontally across
the hedge. When cutting the top part guide the trimmer in a sickle like movement toward the
hedge edges. Cut branches will fall on the ground then.
NOTE!
Do not cut at a time of a generally acknowledged rest time.
NOTE!
If the branches are bigger than the maximal cutting power, they must be removed by
pruning shears.
NOTE!
If heavy pruning is required, you should work in stages.
Step 4 - Trimming
Stopping
The hedge trimmer is equipped with an automatic brake system for quick stop which stops the
knife immediately once the throttle is released to prevent a possible accident.
If you want to switch off the machine, you must move the switch into the “OFF“ position.
Stopping
Depress the throttle lever lock (
D
) and throttle lever (
E
) to active the blade.
D
E
