background image

  

  

15

14

  

  

Customer Helpline 

0845 450 5299

www.gardenservicecentre.co.uk

Customer Helpline 

0845 450 5299

www.gardenservicecentre.co.uk

Troubleshooting

General Troubleshooting

CAUTION!

 Always switch off the engine and pull the ignition cable before starting any inspection 

or adjustment work.

CAUTION!

 If, after making an adjustment or repair to the engine, you let it run for a few minutes, 

remember that the exhaust and other parts will get hot. Thus, do not touch parts that emanate 

heat, as these may burn you.
The following table provides solutions to common problems encountered with the hedge trimmer.

Fault

Possible Cause

Solution

Engine not starting

1. Empty tank

2. Flooded engine

3. Fouled spark plug (remains of 

carbon on the electrodes) 

4. Electrode gap too large

5. Fouled carburetor or its jets 

6. Damaged spark plug connection 

or damaged spark plug 

1. Fill up

2. Close the throttle, pull cord several 

times, if required take out the spark 

plug and dry it   

3. Clean the spark plug, check its 

temperature, replace if needed. 

4. Adjust at 0.6-0.7 mm 

5. Clean the carburetor with air

6. Replace the spark plug.

 

Engine runs too fast 

when idle 

1. Cold engine 

1. Warm up slowly; alternatively 

close the choke a bit. 

Engine does not 

reach its maximum 

speed 

1. Fouled spark plug (remains of 

carbon on the electrodes) spark 

gap to large 

2. Fouled carburettor or its jets 

3. Fouled air filter 

4.Exhaust, exhaust channel  

5. Sealing ring in crankcase not 

sealing properly 

6. Worn cylinders, pistons and 

piston rings 

7. Wrong fuel mix (too much oil) 

8. Bad ignition

1. Clean the spark plug, check its 

temperature, replace if needed. 

Adjust at 0.6-.07 mm.

2. Clean the carburettor with air

3. Clean

4. Take out the exhaust and clean it, 

remove remains of carbon 

5. Replace 

6. Replace the cylinder, piston or 

piston rings, reface the cylinder and 

piston, assembly 

7. Fill up according to the instructions  

8. Adjust the ignition coil gap (0.3-0.4 
mm) 

Engine would not 

stop 

1. The switch  was failed. 

2. The wiring terminal.  was 

disconnected. 

1. Change the switch. 

2. Connect up the wiring terminal. 

Technical Data 

Technical Data Table

Property

Value

Engine type

Single-cylinder, 2-stroke 

Displacement(cc)

22.5 cc

Max power /Engine speed

0.55 kW/7000 min

-1

Tank capacity

450 ml

Cutting speed

1550 min

-1

Ignition

C.D.I

Cutting length

550 mm

Fuel ratio (petrol: 2 cycle motor oil)

40:1

Net weight

5 kg

Sound pressure level L

PA

 (dB)

94 dB K=3 dB

Sound power level L

WA

 (dB)

110 dB

Vibration (m/s

2

)

7.0 m/s

2

Spark type

L8RTF

Disposal

Disposal Instructions

The hedge trimmer and its accessories are made of various recyclable materials. Dispose of the 

hedge trimmer in accordance with your local recycling regulations.

Содержание QJB23













Отзывы: