13
12
Customer Helpline
0845 450 5299
www.gardenservicecentre.co.uk
Customer Helpline
0845 450 5299
www.gardenservicecentre.co.uk
Cleaning the Air Filter
Replacing the Spark Plug
Cleaning the air filter
1) Unscrew the screw from the air filter housing and remove the cap.
2) Remove the air filter.
3) Wash the air filter in warm water (with a small amount of detergent).
4) Rinse the air filter through with clean water.
5) Leave the air filter to dry out completely.
6) Replace the air filter.
7) Replace the cover with the lugs positioned in the notches in the air filter casing.
8) Close the lid, and tighten the bolt again by hand.
Replacing the spark plug
(Spark plugs: L8RTF).
1) Pull off the ignition cable plug.
2) Use the multifunctional tool to unscrew and remove the spark plug.
3) Insert a new spark plug and tighten it carefully with the multifunctional tool.
4) Slip the ignition cable plug back on.
Filter
H=0.6-0.7 mm
Step 3 - Inserting the line spool
l
– Press both lines into opposite slots (line length about 15 cm).
– Thread both lines into the openings of the spool casing.
– Carefully push the line spool with its spring into the spool casing. When doing so, pull the lines
out through the eyelets.
– Continue to hold the line spool tightly. One after the other give a tug on the lines so that they
run out of the openings freely.
– Press the line spool in, and turn it clockwise as far as the stop.
– Keep hold of the line spool and twist it slightly back. The line spool must remain firmly fixed in
the pushed in position.
– Screw the cover back onto the line spool and turn it tight by hand. Adjusting the lines to the
right length.
– Push on the underside of the line spool by hand and pull out both lines out until they are
somewhat longer than the edge of the protective bonnet. The lines are trimmed to the correct
length by the line trimming knife.
How to Replace the Spool/Spool Line
