HELPLINE NO 08454 505299
11
ORIGINAL INSTRUCTIONS
• Before fitting sanding paper, remove any
dust or debris from the hook and loop
system on the base.
• Match the holes in the sanding paper
with the holes in the base.
• Simply press the sanding paper to the
base to attach it.
CAUTION!
Take care to regularly clean out the build up
of dust on the base underneath the sanding
paper and not to let the sanding paper wear
completely down before replacing it. Failure to
observe these two precautionary measures can
lead to damage to the hook and loop on the
base plate and the sanding paper will not
attach properly.
WARNING!
Never use the sander unless the entire base
is fitted with sanding paper.
WARNING!
Always ensure that the tool is switched off and
the plug is removed from the power point
before conducting any adjustments or
maintenance.
• To change the base, first remove the five
fixing screws using a screwdriver.
• Align the sand plate holes with the
base plate and press it firmly in place to
ensure a good attachment ,then tighten
the screws.
• Align the sand paper to the finger and
press it firmly in place to ensure a good
attachment.
5) ATTACHING SANDING FINGER
AND THE SANDING FINGER PAPER
(See Fig. E1-E3)
Fig. E1
Fig. E2
Fig. E3
WARNING!
Always ensure that the tool is switched off and
the plug is removed from the power point
before conducting any adjustments or
maintenance.
There are 9pcs of mouse sanding paper and
9 pcs of finger sanding paper (each 3 x 80#,
100#, 120#) supplied with the multi sander.
80# sanding paper is used for rough sanding.
100# sanding paper is used for normal sanding.
120# sanding paper is used for fine sanding.
Other grades of sanding paper can be purchased
from your local hardware store.
6) SELECTING THE RIGHT GRADE OF
SANDPAPER
