16
Operation Instructions
Two-speed gear control(See Fig. G)
Auxiliary Handle (see Fig.H)
Slide the handle into the drill, rotate the
handle clockwise to release the metal
circle if the circle is not big enough. Turn
the handle to the desired angle. Rotate
the handle anti-clockwise to tighten the
handle.
Drilling
Customer Helpline 0345 640 0800
When drilling hard smooth surfaces, use a center punch to mark the desired hole
location. This will prevent the drill bit from slipping off center as the hole is started.
Hold the tool firmly and place the tip of the bit at the point to be drilled. Depress the
switch trigger to start the tool. Move the drill bit into the work-piece, applying only
enough pressure to keep the bit drilling. Do not force or apply side pressure to
elongate a hole.
When drilling in wood, metal and plastic choose the drill position
.
When drilling in masonry choose the hammer position
. Auxiliary handle can be
used to support hammer work.
WARNING: When drilling in metal, only use HSS drill bits in good condition.
Always use a magnetic bit holder when using short screwdriver bits. When
screw-driving, apply a small quantity of liquid soap or similar to the screw
threads to ease insertion.
Fig.G1
Fig H
Fig.G2
