CHAINTECH 6AJM2, Руководство пользователя

Страница: 35 / 54

User's Manual
30
C. OnChip USB
Enable the on-board Universal Serial Bus (USB) controller if you want to connect
a USB keyboard to your system. Note that if this setting is disabled, you can
still temporarily use a USB keyboard during bootup so that you can enter BIOS
and enable this setting. If you pass the bootup stage without enabling this
function, your PS/2 keyboard will no longer work.
D. USB Keyboard Support
Set to Button Only to control the system power via the button on your system
case. Set to Mouse Left/Right Click to turn on the power via a PS/2 mouse,
and set to Keyboard 98, Hot Key or Password to turn on the power via keyboard.
With Hot Key and Password you must decide on which keys will turn on the
power.
E. IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector
read/write. If your IDE hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal number of block read/writes
per sector the drive can support.
F. Power On Function
Select Button Only to control your computer power by the button on your system
case. Set this function to Any Key to turn on the computer by touching any key
on the keyboard. Set this function to Mouse Click to turn on the computer by
clicking on the mouse. If you set this function to Hot Key or Password you must
designate the keystrokes that will turn on the computer. Note that the power
button is always able to turn on the computer regardless of how this function
is set.
G. Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on
the system board and you wish to use it. If you install an add-in FDC or the
system has no floppy drive, select Disabled in this field.
H. UR2 Mode Select
This function allows you to select an operating mode for the second serial port.
I. Onboard Parallel Port
Select a logical LPT port address and corresponding interrupt for the physical
parallel port.
J. Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select
SPP unless you are certain your hardware and software support one of the other
available modes.
6aja2m2-3.p65 2000/6/13, PM 03:35 30